Table of Contents
Advertisement
Chapter 4: Quick Steps For Setup And Launch
Connect The Access Point To Network And Power
For initial configuration with a direct Ethernet connection and no DHCP
server, be sure to set your PC to a static IP address in the same subnet as
the default IP address on the access point. (The default IP address for the
access point is 192.168.1.10.)
If for initial configuration you use a direct Ethernet (wired) connection (via
crossover cable) between the access point and the computer, you will need
to reconfigure the cabling for subsequent startup and deployment of the
access point so that the access point is no longer connected directly to the
PC but instead is connected to the LAN (either via a Hub as shown in Fig-
ure 4.1, or directly).
ETHERNET CONNECTIONS WHEN USING DHCP FOR INITIAL CONFIGURATION
HUB
Admin PC to Hub
Administrator Computer
LAN
Access Point
Figure 4.1 Ethernet Connections Using DHCP
39
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Advertisement
Table of Contents
