Table of Contents
Advertisement
Appendix D: Troubleshooting
Cluster Recovery
D.2 Cluster Recovery
In cases where the access points in a cluster become out of sync or an access point
cannot join or be removed from a cluster, the following methods for cluster recovery
are recommended.
D.2.1 Reboot Or Reset Access Point
These recovery methods are given in the order you should try them. In all but the
last case (stop clustering), you only need to reset or reboot the particular access
point whose configuration is out of sync with other cluster members or cannot
remove/join the cluster.
• Physically reboot the access point by cycling the power (pressing the
• Reset the access point from its Administration UI. To do this, go to
D-4
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Power button Off, then On).
http://IPAddressOfAccessPoint
Reset button. (IP addresses for APs are on the Cluster > Access Points
page for any cluster member.)
, navigate to Reset Configuration, and click the
Advertisement
Table of Contents
