Enabling Or Disabling The Log Relay Host On The Status; Events Page - Psion Teklogix 9160 G2 User Manual

11.2.1.3 Enabling Or Disabling The Log Relay Host On The Status,

Events Page

To enable and configure Log Relaying on the Status > Events page, set the Log
Relay options as described below and then click Update.
Field Description
Relay Log Choose to either enable or disable use of the Log Relay Host:
If you select the Relay Log checkbox, the Log Relay Host is enabled and the Relay Host and Relay
Port fields are editable.
Specify the IP Address or DNS name of the Relay Host.
Relay Host
Note: If you are using Devicescape Wireless Operations Center, the Repository Server
Specify the Port number for the syslog process on the Relay Host.
Relay Port
The default port is 514.
Update Settings
To apply your changes, click Update.
If you enabled the Log Relay Host, clicking Update will activate remote logging.
The access point will send its kernel messages real-time for display to the remote
log server monitor, a specified kernel log file, or other storage, depending on how
you configured the Log Relay Host.
If you disabled the Log Relay Host, clicking Update will disable remote logging.
should receive the syslog messages from all access points. In this case, use the IP
address of the Operations Center Repository Server as the Relay Host.
Table 11.1 Log Relay Host Settings
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Chapter 11: Maintenance And Monitoring
Log Relay Host For Kernel Messages
123