Table of Contents
Advertisement
Chapter 12: The Ethernet (Wired) Interface
Enabling / Disabling Virtual Wireless Networks On The AP
12.1.3 Enabling / Disabling Virtual Wireless Networks On The AP
If you want to configure the Internal network as a VLAN (whether or not you have a
Guest network configured), you can enable "Virtual Wireless Networks" on the
access point.
You must enable this feature if you want to configure additional virtual networks on
VLANs on the Advanced > Virtual Wireless Networks tab as described in "Config-
uring VLANs" on page 157.
Field
Virtual Wireless Networks
(Using VLANs on
Ethernet Port 1)
12.1.4 Configuring LAN Or Internal Interface Ethernet Settings
To configure Ethernet (wired) settings for the Internal LAN, fill in the fields as
described in Table 12.4.
Field
MAC Address
VLAN ID
136
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Description
• Select
Enabled
and for additional networks. (If you choose this option, you
can run the Internal network on a VLAN whether or not you
have Guest Access configured and you can set up
additional networks on VLANs using the Advanced > Virtual
Wireless Networks tab as described in "Configuring VLANs"
on page 157.)
• Select
Disabled
and for any additional virtual networks on this access point.
Description
Shows the MAC address for the Internal interface for the Ethernet port on this access point. This
is a read-only field that you cannot change.
If you choose to configure Internal and Guest networks by "VLANs", this field will be enabled.
Provide a number between 1 and 4094 for the Internal VLAN.
This will cause the access point to send DHCP requests with the VLAN tag. The switch and the
DHCP server must support VLAN IEEE 802.1p frames. The access point must be able to reach
the DHCP server.
Check with the Administrator regarding the VLAN and DHCP configurations.
Table 12.4 Ethernet Settings For Internal LAN
to enable VLANs for the Internal network
to disable the VLAN for the Internal network,
Advertisement
Table of Contents
