Table of Contents
Advertisement
Appendix C: Security Settings On Wireless Clients And RADIUS Server Setup
IEEE 802.1x Client Using EAP/PEAP
ents.
AND
(2) Configure your IEEE 802.1x wireless clients to use PEAP.
Note: The following example assumes that you are using the Built-in Authenti-
cation server that comes with the 9160 G2 Wireless Gateway. If you are
setting up EAP/PEAP on a client of an AP that is using an external
RADIUS server, the client configuration process will differ somewhat
from this example, especially with regard to certificate validation.
If you configured the 9160 G2 Wireless Gateway to use IEEE 802.1x security mode
. . .
. . . then configure IEEE 802.1x security with PEAP authentication on each client as
follows:
C-12
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Advertisement
Table of Contents
