Promise Technology VTrack M-Class M200f Product Manual page 219

Note: The default name is cim. You cannot change the name or add users.
Note: CIM service must be running to change the password.
The default password is password.
8. Highlight Change Password... and press Enter to change the password.
9. Highlight Old Password and type the current password.
10. Highlight New Password and type a new password.
11. Highlight Retype Password and type the new password again.
12. Press Ctrl-A to save your settings.
To start, stop or restart the CIM service, highlight Start, Stop, or Restart and
press Enter.
Netsend
1. Highlight Netsend and press Enter.
2. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
3. Press Ctrl-A to save your settings.
To start, stop or restart the Netsend service, highlight Start, Stop, or Restart and
press Enter.
Netsend Recipients
Note that the Messenger service must be running on the recipient PC in order to
receive reports.
To add a recipient:
1. Highlight Netsend and press Enter.
2. Highlight Message Recipient and press Enter.
3. Highlight Create New Message Recipient and press Enter.
4. Type the recipient's IP address into the field provided.
5. Highlight Message Event Severity Filter and press the spacebar to change
severity levels.
The selected level and all higher severity levels of severity will be reported.
Severity levels (from lowest to highest) are: Info, Warning, Minor, Major,
Critical, and Fatal.
6. Press Ctrl-A to save your settings.
To change recipient settings:
1. Highlight the recipient whose settings you want to change and press Enter.
2. Type the recipient's IP address into the field provided.
Chapter 5: Management with the CLU
211