3Com SuperStack II 3300 User Manual page 33

System Default
Values
Management Default
Values
Default Passwords
Table 5 SNMP Default Values
SNMP Community
read-only
read-write
By default, no SNMP trap destinations are configured.
After installation, the default system values are as follows:
Table 6 System Default Values
Parameter
System Name
Timeout
You cannot manage the Layer 3 Module until it has a default IP address.
You must assign an IP address to the Layer 3 Module before you can
manage it. To do this, see "Essential Configuration" on page 30.
This IP address is assigned to VLAN 1 when the Switch and Layer 3
Module are restarted. The IP address is passed from the Switch to the
Layer 3 Module.
The IP address is assigned to VLAN 1 because it is the only VLAN on which
the Switch management software can be used.
Once this IP address has been configured, you can use Telnet, the Web
interface or SNMP to manage the Layer 3 Module.
After installation, the default passwords, which specify the level of access
to the system for a user, are as follows:
Table 7 Default Telnet and Web Passwords
Access Level Password
admin No default password
write No default password
read No default password
Factory Default Values
Default value
public
private
Default Value
L3Module-XXXXXX where the last six digits are the
product-unique portion of the MAC address.
Disabled
Privileges
read and write, change passwords, reset
read and write
read
33