3Com SuperStack II 3300 User Manual page 47

Removing Trap
Destinations
1 Enter the following at the top-level menu:
2 Enter the SNMP trap reporting destination address that you want to
Flushing All SNMP
Trap Destinations
1 Enter the following at the top-level menu:
2 Enter
The trap numbers that you enter allow the trap specified by that number
to be sent to the destination address when the corresponding event
occurs. No unlisted traps are transmitted.
If the following message appears:
Trap address invalid or unreachable
make sure that:
The destination address that you entered is a valid end station.
The end station is online.
A valid IP interface is defined on the module.
The module has a route to the destination.
When you remove a trap destination, no SNMP traps are reported to that
destination.
To remove a trap destination:
snmp trap remove
The following prompt is displayed:
Enter the trap destination address:
remove.
The system removes the destination address and displays the previous
menu.
When you flush the SNMP trap reporting destinations, you remove all
trap destination address information for the SNMP module.
To flush the trap reporting destinations:
snmp trap flush
The following prompt is displayed:
Are you sure? (n/y) [y]:
(yes) or (no) as required. If you enter
y n
immediately flushed. If you enter
screen.
Administering SNMP Trap Reporting
, the addresses are
y
, the previous menu appears on the
n
47