3Com SuperStack II 3300 User Manual page 112

112 C 8: S
HAPTER ETTING
Setting the Hello
Timer
Setting the
Retransmit Interval
IP P
ARAMETERS
2 Enter the virtual link ID.
Enter transmit delay (1-65535) [1]:
3 Enter the value of the transmit delay.
The hello timer determines how often the virtual link transmits hello
packets to neighbor routers on the network. Hello packets tell other
routers that the sending router is active on the network. If a router does
not send hello packets for a period of time specified by the dead interval,
the router is considered inactive.
The default value for the hello interval is 10 seconds.
To set the hello timer:
1 Enter the following at the top-level menu:
ip ospf virtualLinks hello
2 The following prompt is displayed:
Select virtual link (1-2|all):
3 Enter the virtual link ID.
Enter Hello packet interval (1-65535) [10]:
4 Enter the hello timer value, in seconds.
You can set the virtual link retransmit interval, in seconds.
The default value for the retransmit interval is 50 seconds.
To set the retransmit interval:
1 Enter the following at the top-level menu:
ip ospf virtualLinks retransmit
The following prompt is displayed:
Select virtual link (1-2|all):
2 Enter the virtual link ID.
Enter LSA restransmit time (1-65535) [50]:
3 Enter the retransmit interval.