3Com SuperStack II 3300 User Manual page 65

1 Enter the following at the top-level menu:
2 Enter the IP address of the interface.
3 Enter the subnet mask of the interface.
4 Enter the VLAN index that is associated with the 802.1Q VLAN ID for this
Modifying an IP
Interface
1 Enter the following at the top-level menu:
2 Modify the existing interface parameters by entering a new value at the
Removing an
Interface
1 Enter the following at the top-level menu:
Make sure that you define a VLAN, as described in your Switch
management guide, before you define an associated IP VLAN interface.
To define an IP interface:
ip interface define
The following prompt is displayed:
Enter IP address:
Enter subnet mask [255.255.0.0]:
Enter VLAN interface index [2]:
VLAN.
You can change the configuration of an interface you have already
defined.
To modify an IP interface:
ip interface modify
The following prompts are displayed:
Select IP interface {1-4}:
Enter IP address [12.0.0.2]:
Enter subnet mask [255.0.0.0]:
Enter VLAN interface index {3|?} [3]:
required prompt(s).
You can remove an interface if you are no longer using it to route on the
ports associated with the interface.
To remove an IP interface:
ip interface remove
The following prompt is displayed:
Administering IP Interfaces 65