3Com SuperStack II 3300 User Manual page 93

Setting the Area ID
Setting the Cost
The default priority value is 1.
To set the interface priority:
1 Enter the following at the top-level menu:
ip ospf interface priority
The following prompt is displayed:
Select IP interfaces (1-2|all):
2 Enter an IP interface.
Enter priority (0-255) [1]:
3 Enter the priority value.
The interface area ID associates the interface you specify with an OSPF
area. See "Defining an Area" on page 85 for more information about
OSPF areas.
Because all routers on the network segment are in the same area, set the
area ID to the same value for each router.
To set the area ID:
1 Enter the following at the top-level menu:
ip ospf interface areaID
The following prompt is displayed:
Select IP interfaces (1-3|all) [1-3]:
2 Select the interface index number(s).
Enter Area ID [0.0.0.3]:
3 Enter the area ID in the form of an IP address.
The interface cost reflects the line speed of the port. To set the cost:
1 Enter the following at the top-level menu:
ip ospf interface cost
The following prompt is displayed:
Select IP interfaces (1-2|all):
Configuring OSPF Interfaces 93