3Com SuperStack II 3300 User Manual page 119

The following are possible responses to a ping:
Using the ping Use the
Command options (see Table 31 on page 120). To change the default ping options,
use the
prompt for the option you want to change.
To ping a host with the default ping options:
1 Enter the following at the top-level menu:
ip ping
2 At the prompt, specify the destination hostname or IP address.
The following example shows a successful ping with the default options:
Select menu option (ip): ping
Enter host name/IP address [0.0.0.0]: 10.204.20.75
Press "Enter" key to interrupt.
PING 10.204.20.75: 64 byte packets
64 bytes from 10.204.20.75: icmp_seq=0. time=16. ms
64 bytes from 10.204.20.75: icmp_seq=1. time=19. ms
64 bytes from 10.204.20.75: icmp_seq=2. time=24. ms
---- 10.204.20.75 PING Statistics ----
3 packets transmitted, 3 packets received, 0% packet loss
round-trip (ms) min/avg/max = 16/20/24
Table 31 lists the default values for a ping command.
If the host is reachable, the Layer 3 Module displays information about
the ICMP reply packets and the response time to the ping. The
amount of information depends on whether the quiet option is
enabled or disabled.
If the host does not respond, the Layer 3 Module displays the ICMP
packet information and the message,
If the packets cannot reach the host, the Layer 3 Module displays the
ICMP packet information and the message,
A host is unreachable when there is no route to that host.
command to ping a destination using the default ping
ping
command and press [Enter] until you see the
advancedPing
Using ping
Host is Not Responding.
Host is Unreachable.
119