Table of Contents
Advertisement
Reset button
On pressing the Reset button, a program restart is initiated at Base-unit.
Start up the Base-unit.
When the Home Page is shown up, press the reset button at the rear panel of Base-unit. Press this button
with a pointed object, e.g. an unbent paper clip, until the factory reset page is shown up as below, for at least
2 seconds.
Use a mouse to connect to Base-unit and click Factory Reset. The Base-unit will reboot after 3 seconds to be
default configuration. All previous settings will be lost and you will need to do the set-up once more.
Or click Cancel to return.
After Reset, all Sensor-buttons must be paired again to Base-unit, because SSID has changed (see chapter
4.2).
Default Configuration
Ethernet
Proxy: None
IP setting: DHCP
Tethering & portable hotspot
Portable Wi-Fi hotspot: ON
SSID: WMB-****,
Security: WPA2 PSK
Frequency: 5GHZ
Channel: 40Hz
9
Advertisement
Table of Contents
