Table of Contents
Advertisement
5000 Series Quick Reference Guide
6. On the 55 dBa (5050/5100) cabinet model printer, grasp the bottom
edge of the front access panel of the printer and lift it to the open
position. A magnetic latch will hold the panel open.
7. Open the lower left and right tractor covers.
To load single-part paper, fold the paper over at a perforation so
that the first two forms are double thick. Later, when printer power
is on, feed these doubled forms out of the printer before adjusting
the print gap.
8. Hand feed the paper, bypassing the lower tractor pins, up through
the printer to the top tractors. After the printer is in operation, the
semiautomatic paper loading feature may be used.
Initially, load the paper so that it will print on the second form
(rather than first form) because a default setting pulls the paper
down into the printer a minimum of 4 inches (see "Setting Top of
14
Note
Note
GEK-99012
Advertisement
Table of Contents
