Table of Contents
Advertisement
5000 Series Quick Reference Guide
4. Align the perforations at the bottom of the first form with the pointers
on the upper tractor doors by using the ↑ ↑ arrow or ↓ ↓ arrow
pushbuttons. Refer to Top View illustration in Step 2, page 12, for
location of the top of form alignment notches on the 5180 model.
5. If the same type of paper has been loaded, reset the print gap wheel
and the paper tension lever to their prior positions. Refer to Top View
illustration in Step 2, page 12, for location of the print gap adjust
knob and paper tension lever on the 5180 model.
6. To accommodate a different width of paper, release the right tractor
lock by pushing down on the small black lever. Load the paper onto
the tractor pins and close the tractor door. Slide the tractor to the
right to remove slack, then lock the tractor again and close the door.
Refer to Top View illustration in Step 2, page 12, for location of the
tractor locking lever on the 5180 model.
Tractor Lock Lever
•
If another type of paper has been loaded, use the following
guidelines for the proper settings of the print gap and paper
tension:
18
GEK-99012
Advertisement
Table of Contents
