Advertisement
Loosen the nuts and lifting each bolt
head in turn, slide the 100cm long square
aluminium extrusion over them.
The rear table support extrusion should
be fitted to the rear with the open side
facing outwards.
If it is difficult to slide on, make sure that
you have slackened the nuts sufficiently
and rock the extrusion gently as you
move it along.
You may need to reach round to the back
of the brackets and unscrew the black
adjusters a little, if they are binding on
the aluminium.
Remove the end cap from the left hand
end of the front rail. Loosen the three M6
bolts in the front flange of the saw table.
End Cap
M6 Bolts
Advertisement
