Advertisement
The guide rail is fitted with front and rear
travel stops.
Move the rear travel stop to the back of
the slot.
Remove the front stop completely and fit
the sliding carriage onto the guide rail so
that the four bearing guides are located
in the matching grooves along the sides
of the rail.
Replace the front stop.
Identify the crosscut fence. Place it with
the open side, face down and the plastic
tip to the right.
Slide the pivot block and the locking
block onto the back side of the fence with
the head of the bolt in the T-slot.
The Locking block has a T-shaped foot
plate, slide it into the slot in the sliding
carriage table.
The Work clamp passes through the
pivot block and locates in the large hole
at the front of the carriage.
The work clamp should be locked in
place using a small grub screw in the
front edge of the carriage.
Fit the flip-over length stop by feeding the
head of the bolt into the T-shaped slot on
the top side of the fence.
The ratchet handle locks the stop in
place.
The stop plate can be flipped over to
engage or disengage it.
From underneath the carriage, push up
the locating stop.
Use a square to check the crosscut fence
is set at 90 degrees to the blade.
If necessary, adjust the stop by loosening
the locking ring and grub screw. Put a
screwdriver into the slot to rotate the stop
to set the angle.
Advertisement
