Advertisement
5) When you are satisfied the blade is aligned, re-tighten the Allen bolts and replace the side panels
Adjusting the Blade Tilt Limits
Threaded Shaft
Threaded Nut
90 Degree
Limiting Collar
Raise the blade to full height and remove
the blade guard.
Remove both blue side panels from the
base of the saw. The adjustment handwheel
will need to be removed but should then be
replaced and secured on the threaded shaft.
90 Degree Stop
With 4mm Allen Key, loosen the limiting
collar fitted to the threaded shaft
Using a suitable square, accurately adjust
the blade to 90 degrees.
Ensure that the square is positioned
between teeth and is flat against the plate of
the blade.
Hold the limiting collar firmly against the
Threaded Nut and retighten the grub screw.
Advertisement
