Advertisement
Blade Removal and Replacement
Adjusting Blade Alignment
1) Disconnect the saw from the power supply and remove the two blue side panels from the main body.
2) With a 4mm hex key loosen, but do not fully undo, the four Allen bolts located in the main cast iron table located
just in front and behind the saw blade. There are four corresponding 10mm Nyloc nuts underneath the table.
Allen Bolts
3) By holding the motor it is then possible to adjust the alignment of the sawblade in the table slot.
4) Measure the distance between the blade and the T slot in the table at both the front and rear of the blade, ensuring
that both measurements are the same. Also, ensure that the blade will clear the table and insert when fully tilted.
Unplug the saw from the power source.
Raise the blade to its maximum height and
remove the saw guard from the riving knife.
Remove the right hand table insert, using a
4mm Hex key to remove the two screws.
Use the special spanner supplied, lock the
spindle by fitting it over the black locking
washer.
Then use a 13mm spanner to undo the
blade locking bolt.
Remove the bolt, flat washer and locking
washer. The blade can now be removed
from the shaft.
Reverse this procedure to fit the new blade.
Nyloc Nuts
Advertisement
