Advertisement
Assembly
While the machine is on its side, take the
four feet from the bag of parts and screw
them into the four holes in the base.
These feet can be adjusted by means of
a spanner to level the saw table after the
machine has been put into place.
Return the saw to a vertical position.
The cast iron table is coated with a layer
of grease to prevent rust. This is easily
removed with a soft cloth moistened with
paraffin or WD40.
Raise the saw blade by turning the fitted
hand wheel at the front of the machine
clockwise.
Fit the other hand wheel from the bag of
components to the spindle on the right
hand side of the saw. Tighten the grub
screw so that it engages with the flat on
the spindle.
Turn the wheel clockwise until the blade
is vertical, if it is not already in this
position.
There are two brackets at the rear of the
saw.
Each one has two hex headed bolts and
nuts passing through it.
Advertisement
