Advertisement
Fit the two support arms which will carry
the guide rail for the sliding carriage.
These are bolted to the left hand side of
the table with four countersunk bolts
Fit the wide guide rail extrusion by sliding
it over the heads of the eight securing
bolts.
Position the sliding carriage guide rail so
that the back edge of the rail is level with
the back side of the rear support rail.
Ensure the guide rail is parallel to the
saw blade before tightening the eight
nuts.
Before fitting the sliding carriage, it
should be noted that the two outboard
bearing wheels are mounted on eccentric
holes.
Should it ever be necessary, any wear to
the carriage can be adjusted with the aid
of a 14mm spanner.
Advertisement
