Riving Knife Adjustment - Charnwood W619PSF Owner's Manual

Riving Knife Adjustment

To fit inside the packing crate, the riving knife is set by the factory in a lower position which restricts the
cutting depth of the table saw. Follow these instructions to raise the riving knife and use the full 60mm
cutting depth.
Check the Sliding carriage table is level
to the main table. It should be level or
slightly higher (up to 1mm) than the main
table to allow a clamped work piece to
move across the main table.
If necessary, loosen and adjust the four
silver support brackets to lift or level the
sliding carriage.
All four nuts holding the brackets on each
arm need to be loose when making an
adjustment.
The sliding mitre fence can be used on
either side of the blade.
Slide the T-shape bar in the slot in the
main table.
The large knob is used to unlock the
angle, which can be read from the scale
on the front.
Ensure that the machine is isolated from the
power supply.
Raise the blade to its maximum height
using the blade height adjustment hand
wheel at the front of the saw.
Remove the two countersunk screws from
the right-hand part of the table insert using
a 4mm hex key. Lift out the insert