Charnwood W619 Adjustment

RIVING KNIFE ADJUSTMENT
To fit inside the packing crate, the riving knife is set by the factory in a lower position
which restricts the cutting depth of the table saw. Follow these instructions to raise
the riving knife and use the full 60mm cutting depth.
1) Ensure that the machine is isolated from the power supply.
2) Raise the blade to its maximum height using the blade height adjustment
hand wheel at the front of the saw.
3) Remove the two countersunk screws from the right-hand part of the table
insert using a 4mm hex key. Lift out the insert.
W619 TABLE SAW