Page 1
TABLE SAW RIVING KNIFE ADJUSTMENT MODEL: W650 It is possible that the factory setting of the riving knife restricts the maximum cutting depth of the saw. If this is the case, the riving knife can be adjusted as follows: 1) Ensure that the machine is isolated from the power supply.
Page 2
This allows the crown guard to rotate further on the pivot point and remain parallel to the table after the adjustment. Use a sharp craft knife, carefully extend the slot at the rear of the guard by approximately 7mm. You might find this easier if the two sides of the guard are first split.
Page 3
7) Raise the riving knife and crown guard assembly, so that the crown guard is situated just above the top of the saw blade. If necessary adjust the riving knife so that there is an even gap between the leading edge of the riving knife and the radius of the saw blade.