Page 1
W650 Table Saw Blade Alignment Instructions 1) Disconnect the saw from the power supply and remove the blue panel from side of the saw base. 2) Loosen, but do not fully undo, the four M8 hex cap head bolts under the front and rear of the cast table using a 6mm hex key.
Page 2
6) When you are satisfied the blade is aligned, re-tighten the six bolts and replace the side panel prior to use. Tel. 01530 516926 Fax. 01530 516929 email: sales@charnwood.net Website: www.charnwood.net Charnwood, Cedar Court, Walker Road, Bardon, Leicestershire, LE67 TU, England...