Advertisement
An alternative configuration is available for the sliding carriage. The fence can be assembled onto the back
edge of the table in a mirror image of the standard configuration.
The work piece is loaded against the back edge of the fence and then fed onto the blade.
Using this configuration, the crosscut capacity can be increased and the sliding carriage guide rail can be
moved backwards so that it does not obstruct the operator.
Cross Cutting With Sliding Carriage
The sliding carriage is more suitable when
working with large flat panels.
To use the sliding carriage: Pull the table all
the way forward.
Set the flip over stop to the desired width of
cut when required.
If an angle is to be cut, undo the 2 thumb
screws and ratchet lever, swing the fence to
the desired angle and lock them both off
If necessary, undo both thumb screws and
adjust the fence so that the plastic tip is just
clear of the blade.
Load the wood onto the carriage and screw
down the work clamp to secure it.
Press the start button and push the wood
through the saw blade.
Advertisement
