Advertisement
Troubleshooting Guide
Problem
Machine does not start
Only starts when Green
button is held down
Machine does not run but
buzzing noise heard from
motor
Saw vibrates
Cuts are slow, wood is
blackened
Saw stalls
Wood binds on rear of saw
blade
Lower saw guard fills with
dust
Blade tilt or blade height
difficult to adjust
Cause
Blown Fuse
Loose switch terminal
Faulty switch
Doors not closed
Faulty switch
Failed capacitor
Damaged teeth on saw blade Check & replace the blade
Floor stand is loose
Saw blade is blunt or
damaged
Feed rate too high
Rip fence is not parallel to
blade
No extraction fitted or
extraction not working
efficiently
Adjusting rod obstructed by
dust build up
Remedy
Replace Fuse
Inspect back of switch
Replace switch
(The machine is fitted with a
safety interlock switch, it will
not run if a door is open)
Replace switch
Replace the motor start
capacitor.
Check all nuts and bolts for
tightness
Examine the blade. If any
Tungsten tips are missing or
broken the blade should be
replaced. If the tips are blunt,
the saw blade may to be
professionally sharpened.
Slow down
Bring the fence up to the
blade and re-align the fence
so it is parallel, by adjusting
the 2 small set screws
located on the guide rail
brackets. (see assembly
instructions for more details)
It is essential to use a
vacuum extractor or chip
collector with this machine. If
one is being used, check for
blockages in the hose
clean and lubricate the
mechanism
Advertisement
