Advertisement
Using The Table Saw
Work
Sliding
Stop
Carriage
On/Off
Switch
On/Off Switch
Slide the red section upwards and then lift the hinged cover. This will give you access to the green start and
red stop buttons. Pressing the red section of the cover will stop the saw.
To turn the saw on, press the green button. Wait for the blade to reach its maximum speed of rotation
before commencing with the cut.
The machine is fitted with an NVR (No Voltage Release) switch. This type of switch is designed so that if
the machine is disconnected from the mains whilst running and then reconnected, the motor will not
automatically restart.
Blade Height
Adjustments to the blade height should be made only when the saw is not running.
Turn the round hand wheel on the front, to set the blade to the required depth. Turn anticlockwise to lower
the blade, turn clockwise to raise the blade. The blade height should always be set so that only the carbide
tips of the blade (approx. 5mm) projects above the wood.
Blade Angle
Adjustments to the angle of cut should be made only when the saw is not running.
To tilt the blade for making bevel cuts, undo the blade angle lock, rotate the hand wheel to the required
angle using the scale provided for guidance. Lock the angle by pressing down the locking lever.
Work
Clamp
Blade Angle
Blade Height
Lock
Blade
Guard
Adjustable
Adjuster
Feet
Mitre
Rip
Fence
Fence
Blade Angle
Adjuster
Advertisement
