Latched Manual - EWM TIGSPEED OSCILLATION DRIVE 45 COLDWIRE Operating Instructions Manual

Design and function
Configuring the welding machine for mechanical arc fusion welding
5.2.3.3

Latched manual

This operating mode differs from non-latched operation in the following ways:
•
Wire feeding is started by pressing and releasing (tapping) BRT 2.
•
By tapping you can switch to the reduced wire feeding.
•
By pressing and releasing (tapping) BRT 2 again, wire feeding will stop. (It is not necessary to keep
the torch trigger pressed. This is especially helpful with long welding seams.)
Stopping the welding process:
•
Keep BRT 1 pressed for a period longer than the set tapping time.
Wire feeding can already be stopped by pressing the BRT2 torch trigger.
For this to work, the "3rd cycle" parameter has to be activated, > see 5.2.4 chapter.
34
Figure 5-23
099-000181-EW501
30.06.2017