Dedicated Micros TransVu Operation Manual page 40

Alarm/VMD Reporting
When an alarm is triggered the TransVu will send a message via the serial port or over the network using
PPP.
This section identifies the details of the receiving station and the route the message will take.
When using the Ethernet network to transmit the alarm message all configuration for the remote receiving
station can be carried out using the web interface, to enable PPP via a modem the 'profiles' (\etc\profiles) file
will need to be edited.
Function
Primary Host
Secondary Host
Profile
Dedicated Micros © 2006
Description
This is the IP address or name of the initial host that the TransVu will transmit an alarm
message to.
If the TransVu is unable to contact the primary host then it is possible to identify an
alternative route and a secondary host.
If there is only one alarm receiving IP address, you must enter the details in both the
primary and secondary connection settings.
This is the medium that the TransVu will use to make the connection to the primary or
secondary host.
Note: If the connection is via the serial port the profile will be the username configured in
the 'profiles' file in the \etc directory on the TransVu.
39