Dedicated Micros TransVu Operation Manual page 31

receipt of the corresponding alarm.
Function
Select Zone
Cameras
Zone on entry route
Zone on exit route
Entry initiator
Exit terminator
Text Only Alarm
30
Description
This allows you to select one or more cameras that will be associated with the Alarm Zone
being configured. Each camera will become part of the 'alarm sequence' when this alarm
zone is triggered.
This is part of the Advanced Alarm Features and will create deferred alarms while the
entry time is active.
The primary alarm input will initiate the 'entry counter' to count down; this has specific
alarm areas associated with it. If someone enters the specified alarm areas during the
count down process the alarm will not be triggered allowing them to reach the alarm
panel to switch the alarm off.
This is part of the Advanced Alarm Features and will create deferred alarms while the exit
timer is active.
This is the similar to the zone on entry option, but works in the reverse, this allows an
Operator to switch on a building alarm and will give them a set time period to exit the
building and allow them to pass through specified alarm areas without triggering the
alarm.
This is part of the Advanced Alarm Features and will trigger the entry timer if the system is
set. This is a count down timer that will automatically start when the 'primary' alarm trigger
(e.g. front door) is actioned and this ensures the alarm system is not activated by other
specified alarm triggers for the set time.
This is part of the Advanced Alarm Features and will when enabled will instantly set the
alarm rather than waiting for the set countdown time.
A text message, without any image attachments, will be transmitted when the alarm zone
is triggered. This may be used in situation where a camera is not associated with an
alarm zone.
Dedicated Micros © 2006