Dedicated Micros TransVu Operation Manual page 32

Function
Switch System into
SET Operation
mode
Create Database
Entry
Change Standard
Record Rate
Change Variable
Record Rate
Connect/Dial on
Alarm
24 Hour Alarm
Record still image
Protect Alarm
Images
Archive Alarms
Switch Spot Monitor
to Primary Camera
Dedicated Micros © 2006
Description
This is the system set option which will enable all alarms and VMD for all zones.
An alarm entry will be added to the database, the zone title will be used as part of the
entry information.
This will change the record rate of the cameras that have been identified in the Standard
Record Rate page (refer to Camera Set-up for information on how to configure standard
record rate). The cameras will switch to the alarm record rate specified.
This changes the record rate of the cameras that are selected in the alarm zone to the
variable record rate previously specified (refer to How to Configure Variable Record Rate
in this section of the manual). Each of the cameras must have an alarm record rate
specified.
The TransVu will automatically connect to the remote alarm monitoring station defined.
Note: The Viewer application requires an unlock code for this function to operate.
This will force the alarm zone to be permanently active (24/7).
This will record a still image of the trigger along with the standard recording. Still images
are accessible through the Live page of the web interface. This will also add the word
'alarm' to the title header.
Any alarm images associated with the alarm zone will be protected from being
overwritten. To unprotect the files refer to Alarms/VMD>Alarm Image Protect/Unprotect
Images.
This will force the alarm images to be automatically sent via FTP to a central FTP server,
refer to How to Set up Connect on Alarm in this section of the manual.
When an alarm is triggered it is possible to switch the Primary Camera to be displayed on
the Spot Monitor output. This requires the parameter '24 Hour Alarm' to be enabled.
31