Specifications - Siemens SITRANS RD300 Operating Instructions Manual

SITRANS RD300

SPECIFICATIONS

Except where noted all specifications apply to operation at +25°C.
General
DISPLAY
DISPLAY
INTENSITY
DISPLAY
UPDATE RATE
OVERRANGE
UNDERRANGE
DISPLAY
ASSIGNMENT
PROGRAMMING
METHODS
NOISE FILTER
FILTER BYPASS
RECALIBRATION All ranges are calibrated at the factory. Recalibration is
MAX/MIN
DISPLAY
PASSWORD
NON-VOLATILE
MEMORY
A5E31917845
Upper display: 0.6" (15 mm) high, red LEDs
Lower display: 0.46" (12 mm) high, red LEDs
6 digits: each (-99999 to 999999), with lead zero blanking.
Eight user selectable intensity levels
5/second (200 ms)
Display flashes
Display flashes
Display lines 1 & 2 may be assigned to rate, total, grand
total, alternate (rate/total, rate/grand total, rate/units,
total/units, and grand total/units), set points, max/min, units
(lower display only), and Modbus input. Additional displays
are available if parameter total is off, and parameter d-
SCAL is on: gross, alternating gross/net, PV1, PV2, and
PCT.
Four front panel buttons, digital inputs, or PC via MeterView
Pro software.
Programmable from 2 to 199 (0 will disable filter)
Programmable from 0.1 to 99.9% of calibrated span
recommended at least every 12 months.
Max/min readings reached by the process are stored until
reset by the user or until power to the meter is turned off.
Three programmable passwords restrict modification of
programmed settings and two prevent resetting the totals.
Pass 1: Allows use of function keys and digital inputs
Pass 2: Allows use of function keys, digital inputs and
editing set/reset points
Pass 3: Restricts all programming, function keys, and
digital inputs.
If Total is enabled:
Total: Prevents resetting the total manually
Gtotal: Prevents resetting the grand total manually
All programmed settings are stored in non-volatile memory
for a minimum of ten years if power is lost.
SITRANS RD300 – OPERATING INSTRUCTIONS
999999
-99999
Page 95