SIT SITRANS RD300RANS RD300
Display Functions and Messages
The meter displays various functions and messages during setup,
programming, and operation. The following table shows the main menu
functions and messages in the order they appear in the menu.
Display
setup
Input
mA
volt
Total
d-SCAL
units
rate
total
Gtotal
Dec pt
prog
InCAL
sCalE
Cal
Inp 1
Dis 1
Inp 2
Dis 2
Error
T tb
T CF
Page 18
Parameter
Setup
Input
4-20 mA
0-10 VDC
Total
Dual-scale
Units
Rate
Total
Grand Total
Decimal point
Program
Input
Calibration
Scale
Calibrate
Input 1
Display 1
Input 2
Display 2
Error
Total time
base
Total
SITRANS RD300 – OPERATING INSTRUCTIONS
Action/Setting Description
Enter Setup menu
Enter Input selection menu
Set meter for 4-20 mA input
Set meter for 10 VDC input
Enable or disable totalizer features
Enter d-SCAL menu and select Yes for
dual- scale or No for single scale display
Select the display units/tags
Select the display units for rate
Select the display units for total
Select the display units for grand total
Set decimal point for rate, total, grand total
Enter the Program menu
Enter the Input Calibration menu
Enter the Scale menu
Enter the Calibrate menu
Calibrate input 1 signal or program input 1
value
Program display 1 value
Calibrate input 2 signal or program input 2
value (up to 32 points)
Program display 2 value (up to 32 points)
Error, calibration not successful, check
signal or programmed value
Program total time base
Program total conversion factor
A5E31917845