Configuration Mode - Printronix T3306 Setup Manual

NOTE: Parameters marked with an asterisk (*) indicate the factory default
Option
AutoEject
Auto Wrap
Define CR Code
Define LF Code
Ext Execute Copy
Configuring the Printer
Table 3–3. IGP/PGL Configuration Mode Options
value. The printer must be off-line to enter the configuration
structure.
Parameter
Value
DISABLE *
ENABLE
DISABLE *
ENABLE
CR = CR *
CR = CR + LF
LF = LF *
LF = CR + LF
DISABLE*
ENABLE
Comments
If the last page of a job is only 1/2 full (the data does not fill
the entire page), you can instruct the printer to eject the
page or leave it in the printer. ENABLE causes the printer
to eject the last page after the entire page has been
processed and printed. DISABLE instructs the printer to
eject the page only if you send a Page Eject command or
when the printer receives the next print job.
Controls automatic "wrapping" of text to the next line down
when the text exceeds the right margin.
DISABLE truncates text beyond the page margin until a CR
or CR + LF is received. ENABLE automatically inserts a CR
+ LF after a full print line.
If a proportional spaced font is used, this option is ignored
and the printer does not wrap text.
When CR = CR + LF, a line feed is automatically inserted
after each CR received, otherwise data passes through
unchanged.
When LF = CR + LF, a CR is automatically inserted before
each line feed is processed, otherwise data passes through
unchanged.
If DISABLED, dynamic data, overlay data, etc. are not
allowed if the optional Form Count parameter is specified as
part of the Execute command.
If ENABLED, dynamic data, overlay data, etc. are allowed
within a form in which the Form Count parameter is
specified in the Execute command. In this case, the exact
same form (with identical dynamic data, etc.) is printed for
whatever the Form Count is. Also, each form is printed on
a separate page.
3–45