Media Loading; Roll-Fed - Printronix T3306 Setup Manual

Media Loading

The following procedures describe loading of the various media.
NOTE: The optional internal rewinder and rewind bracket are shown on all

Roll-Fed

To install roll-fed media, perform the following steps.
1. Open the media supply door.
2. Slide a roll of the chosen media onto the media hub assembly, as far as
possible toward the inside of the printer as shown in Figure 2–5.
3. Raise the printhead latch wing, and rotate it counterclockwise one
half-turn to unlock the printhead. Swing the printhead to the raised
position as shown in Figure 2–5 and
4. Route the media under the bouncer assembly and between the upper
and lower media guides, as shown in
5. Continue feeding the media under the printhead until the media exits the
printhead assembly.
Idler Rollers
2–8
media loading drawings.
Upper Media
Guide
Ribbon
Take–Up Hub
Printhead
Assembly
Figure 2–5. Major Internal Components
Figure 2–6.
Figure 2–7.
Media Hub
Assembly
Printhead
Latch Wing
Media Rewind
Hub (Optional)
Setting Up the Printer
Ribbon Supply
Hub
Bouncer
Assembly