Table of Contents
Advertisement
Chapter 3
Connecting the Cisco ONS 15540 ESPx
Figure 3-39 Locking the Drawer
Step 4
Use the MTP cable installation tool to push the MTP connector of the cable into
the adapter on the mux/demux module until the connector snaps into place.
Step 5
Route the MTP cable down through the cable management tray. Pull the cable out
the left side of the tray.
Step 6
Route the cable down the left side of the chassis and into the drawer.
Continue to route the cable through the drawer around the round cable retainers
Step 7
to the right side.
Step 8
Pull the cable up out of the right side of the drawer and the back up through the
cable management tray.
Step 9
Insert the MTP connectors into two different MTP adapters on the desired line
card motherboards. (See
78-16436-01
Connecting the 10-GE Transponder Module
Figure
3-40.)
Cisco ONS 15540 ESPx Hardware Installation Guide
3-53
Advertisement
Table of Contents
