Powering Up the Shelf
Figure 2-33 Removing the Terminal Block Access Panel
Snap the cable connector of the short DC power cable into the cable strain relief
Step 3
bracket. (See
Insert the cable through the left rear of the chassis and connect the leads to the
Step 4
terminal blocks (see
•
•
Note
Cisco ONS 15540 ESPx Hardware Installation Guide
2-54
Terminal block
access panel
Figure
2-33.)
Figure
Black lead to RTNA.
Red lead to –48A.
The ground connections should always be connected first and
disconnected last.
Chapter 2
2-34) in the following sequence:
Installing the Cisco ONS 15540 ESPx
78-16436-01