Table of Contents
Advertisement
Installing and Removing Modules
Installing Mux/Demux Modules
Step 1
Step 2
Step 3
Step 4
Step 5
Installing 2.5-Gbps Type 1 Transponder Modules
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco ONS 15540 ESPx Hardware Installation Guide
2-24
To install the mux/demux modules follow these steps:
Remove the failed module or the filler module from the motherboard.
Take a new module from the shipping container.
Insert the module carefully into the motherboard slot while guiding the upper and
lower edges of the module in the tracks until its connectors come into contact with
the backplane connectors. You hear a click when it is connected.
Attach the appropriate cables.
Check the LEDs to ensure proper installation. See
mux/demux motherboard LED descriptions.
Save the filler modules with the packaging material.
To install the 2.5-Gbps Type 1 transponder module, follow these steps:
Remove the failed module or the filler module from the 2.5-Gbps line card
motherboard.
Take a new module from the shipping container.
Insert the module carefully into the motherboard slot while guiding the upper and
lower edges of the module in the tracks until its connectors come into contact with
the backplane connectors. You hear a click when it is connected.
Attach the appropriate cables.
Check the LEDs to ensure proper installation. See
2.5-Gbps Type 1 transponder module LED descriptions.
Save the filler modules with the packaging material.
Chapter 2
Installing the Cisco ONS 15540 ESPx
Table 1-8 on page 1-16
Table 1-14 on page 1-25
for
for
78-16436-01
Advertisement
Table of Contents
