Table of Contents
Advertisement
Connecting PSMs
Cabling PSMs
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco ONS 15540 ESPx Hardware Installation Guide
3-10
To attach and route MU fiber optic cables for PSMs connected to mux/demux
modules, follow these steps:
Use MU connectors to make your east and west connections from the PSM to the
equipment appropriate for your configuration.
Attach MU connectors to the mux/demux OUT/IN connections on the PSM.
Route the cables down through the vertical cable guides and in through the left
side of the cable storage drawer.
Continue to route the cable through the drawer around the round cable retainers
to the right side.
Pull the cable up out of the right side of the drawer and back up through the cable
management tray.
Insert the other end of the MU connectors into the trunk IN/OUT ports on the
desired mux/demux module.
steps with the PSM in slot 0, subslot 0 and an 8-channel mux/demux module in
slot 0, subslot 1.
Chapter 3
Connecting the Cisco ONS 15540 ESPx
Figure 3-2
shows the connections described in these
78-16436-01
Advertisement
Table of Contents
