Connecting the Cables
Figure 3-12 Locking the Drawer
Use the MTP cable installation tool to push the MTP connector of the cable into
Step 4
the adapter on the mux/demux module until the connector snaps into place.
Route the MTP cable down through the cable management tray. Pull the cable out
Step 5
the left side of the tray.
Route the cable down the left side of the chassis and into the drawer.
Step 6
Pull the cable through the vertical cable guides on the side of the cable storage
Step 7
drawer.
Route the cables through the storage drawer as directed in Step 5 to Step 7 in the
Step 8
"Direct Connections with Cable Storage Drawers"
Close the cable storage drawer once the cables are routed out of the right side and
Step 9
you unlock the drawer.
Open the cross connect drawer appropriate for your system configuration. See
Step 10
Step 1 to Step 3 above for drawer opening details.
Flip the latches on the cross connect panel up and use them to pull the panel up.
Step 11
(See
Cisco ONS 15540 ESPx Hardware Installation Guide
3-24
Figure
3-13.)
Chapter 3
Connecting the Cisco ONS 15540 ESPx
section.
78-16436-01