Table of Contents
Advertisement
Powering Up the Shelf
Figure 2-25 Power Connector and Two-Pin Molex Connector
Power connector
Connect the other end of the two-pin Molex cord to the chassis.
Step 8
Connect the other end of the power cord to an AC-power input source. (See
Step 9
Figure
Caution
Cisco ONS 15540 ESPx Hardware Installation Guide
2-46
Two-pin Molex
2-26.)
In a system with multiple 15540-PWR-AC power supplies, connect
each power supply to a separate AC-input power source. In case of a
power source failure, the second source is still available and can
maintain maximum overcurrent protection for each power connection.
Chapter 2
Installing the Cisco ONS 15540 ESPx
+
-
INPUT OK OUTPUT OK
78-16436-01
Advertisement
Table of Contents
