White - Directed XpressKit Installation Manual

Quick Reference Guide
DBALL2 TL6 -
Vehicle Takeover
Note: There is no vehicle takeover in this firmware. The vehicle will
shut down as soon as a door is opened.
Pit Stop Mode
The Pit Stop Mode feature is practical when you need to stop and run an errand,
but wish to keep the engine running.
Stop the vehicle in a safe parking spot
1
and put the gear in Park (P).
2
Press the button to remote start the vehicle.*
The parking lights will flash once to indicate the
vehicle is now in Pit Stop mode.
It is now safe to leave the
vehicle with the Smart Key in hand.
3
Note: We recommend that you always
of your vehicle when leaving it unattended.
* Your aftermarket remote may differ from the model shown in the illustrations.
Stop & put vehicle in Park (P)
remote start
button
engine running and exit the
lock the doors
E xit vehicle with
Smart Key
List of Available Commands
Note that the information below is for Viper, Clifford and Python models. Icons and
commands may differ depending on the remote brand and model purchased. Refer
to your authorized installation center for more information.
Button(s)
P
&
Press
* x1 +
x3 +
x1 +
Actions
Press & hold for 1 second to lock.
Press & hold for 1 second to unlock.
Press & hold for 1 second to remote
start.
Press & hold for 5 seconds to activate
the trunk release (optional).
Press once, then to activate the
right sliding door.
Press 3 times, then to activate
the left sliding door.
Press once, then to reset the
remote starter runtime.
© 201 Directed. 7 All rights reserved.