Directed XpressKit Installation Manual page 24

Platform: DBALL2
Firmware TL6 :
Module Reset
A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed
to the module using the web config tool will not be affected.
D2D Installation
If required for your installation, c
14-pin harnesses to the module Press
p rogramming button
OR
1
W2W Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module Press
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the
2
p rogramming button.
Hard Reset
Warning gainst xecuting a Hard Reset! A E
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings
(such as RFTD and D2D options) may have to be reconfigured. See the
D2D Installation
If required for your installation, c
14-pin harnesses to the module Press
p rogramming button
1
OR
W2W Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module Press
button, then connect the 14-pin harness to the module.
Wait 3 seconds until the
2
until the LED starts to flash orange
3
Release the programming button. The
onnect the 10-pin 12-pin
. and hold the
, then connect the 4-pin D2D harness.
. and hold the rogramming p
LED turns ON solid orange then release the
The LED then turns ON solid red.
onnect the 10-pin 12-pin
. and hold the
, then connect the 4-pin D2D harness.
. and hold the rogramming p
LED turns ON solid orange
and red.
LED turns
, &
th
5
st
1
st
1
Feature & Option List
, &
th
5
st
1
st
1
, and w ait 10 more seconds
ON solid red.
Rev.: 20 708 1
Page 24
rd
3
nd
2
th
4
th
4
nd
2
rd
3
& &
Solid Release Solid
section of this guide.
rd
3
nd
2
th
4
th
4
nd
2
rd
3
&
Solid Flashes
&
Release Solid
© 201 Directed. 7 All rights reserved.
15