Directed XpressKit Installation Manual page 23

Platform: DBALL2
Firmware TL6 :
Module Programming
Refer to the LED Diagnostics section for more information and for troubleshooting purposes.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning! To take advantage of advanced features, you must use Xpress
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the Flash Module
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH button.
When the flashing operation is successful, you can proceed with the programming instructions below.
D2D Installation
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
OR
W W Installation 2
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
1
Wait until the LED turns
Wait 4 seconds before turning the ignition ON.
2
The LED flashes orange if
( See page 3 for more information .
Press the ush-to- tart P
3
ON . The green LED
If the LED flashes orange,
4
The LED turns solid orange for 3 seconds: the programming is done.
Otherwise proceed to the next step.
5
Press the PTS button
You have successfully completed the module programming sequence.
button.
ON solid red.
the OEM remote starter
)
S ( PTS ) button twice to turn the ignition
turns ON for 3 seconds and shuts
press the programming button 5
once more to turn the ignition
VIP 4.5 (and higher) or the Directechs Mobile app.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select FLASH YOUR MODULE
instructions.
th
4
st
1
st
1
is detected.
ENGINE
PUSH 2X
START
OFF .
STOP
times .
Flashes
OFF .
Rev.: 20 708 1
Page 23
XKL oader3.
and follow the on screen
rd
3
nd
2
rd
3
nd
2
Solid
Flashes
& &
Solid x3 Secs Off
& &
Press x5 Solid x3 sec.
ENGINE
PUSH 1X
START
STOP
© 201 Directed. 7 All rights reserved.
15