Resetting; Edid Minder - Extron electronics SW HD 4K PLUS Series User Manual

Auto-input switch modes
The SW HD 4K PLUS switchers provide three auto switch modes, which can be selected
via SIS commands (see
the PCS help file).
• Mode 0 (disabled mode) — Auto-input switching is disabled.
• Mode 1 (user‑assigned mode) — The switcher selects the input to which you assign
priority (via SIS commands). If no priority is assigned, the switcher selects the active
input with the highest number (default user selection).
• Mode 2 (input memory priority mode) — The switcher selects the most recently
applied input, and retains a history of the order in which active inputs are connected
to the unit. If an active input is removed, the switcher switches to the most recently
selected input.
Mode 2 timeout — Using SIS commands, you can set the number of seconds (0 to
250) the switcher delays before selecting the most recent input.

Resetting

Resetting from the front panel, described in this section, returns the unit to its factory-set
values.
NOTE: IP settings, including IP address, subnet mask, gateway address, unit name,
DHCP setting, and port mapping, are not affected by this command.
To reset the switcher to its factory default settings:
1. Using a stylus or small screwdriver, press the recessed
hold it for 3 seconds.
Pressing this button is equivalent to entering the E
Resetting commands

EDID Minder

EDID Minder ensures that a source device connected to the SW HD 4K PLUS input
continuously recognizes the EDID of a sink device, even if the sink is not physically
connected. By default, the EDID is set to 1080p @ 60 Hz with 2-channel audio.
EDID can be set to match output rate, a custom user-defined EDID, or a factory setting.
A variety of EDID are available to be loaded via PCS and assigned to the inputs (see
the SW HD 4K PLUS PCS Help file, provided with the PCS program, for information on
assigning EDID).
Auto‑input Switch Mode commands
on page 23).
SW HD 4K PLUS Series • Operation
on page 19) and PCS (see
button on the front panel and
R
} SIS command (see the
ZXXX
14