Edid Minder - Extron electronics SW HD 4K PLUS Series User Manual

Mode Activation
Reset
Press and hold down the
System
the all the front panel LEDs blink once
Settings
(at 3 seconds). Then, press
momentarily (for less than 1 second).
Reset IP
Press and hold down the
and System
all the front panel LEDs blink twice
Settings
(approximately 10 seconds). Then,
R
press again momentarily (for less
than 1 second).
Reset All Using an Extron Tweeker or other
Settings
small screwdriver, press and hold in
to Factory
R
the recessed
Defaults
connecting power to the switcher.

EDID Minder

EDID Minder ensures that a source device connected to the SW HD 4K PLUS input
continuously recognizes the EDID of a sink device, even if the sink is not physically
connected. By default, the EDID is set to 1080p @ 60 Hz with 2-channel audio.
EDID can be set to match output rate, a custom user-defined EDID, or a factory setting.
A variety of EDID are available to be loaded via PCS and assigned to the inputs (see
the SW HD 4K PLUS PCS Help file, provided with the PCS program, for information on
assigning EDID).
Reset Mode Summary
R The unit returns to factory defaults except
button until
for the firmware version and IP settings.
R
again
R The device reverts to the factory defaults
button until
except for the firmware version.
•
All system settings revert to the factory
defaults.
•
All user modifiable configurations are
reset to default values, including IP
settings (IP address, subnet mask,
gateway address, unit name, DHCP
setting, and port mapping) and real-time
adjustments.
•
All user loaded files are deleted.
NOTE:
The device reverts to the factory firmware,
IP, and system default settings.
(Reset) button while
•
The unit reverts to the factory-installed
firmware version.
•
All system settings revert to the factory
defaults.
•
All user modifiable configurations are
reset to default values, including IP
settings (IP address, subnet mask,
gateway address, unit name, DHCP
setting, and port mapping) and real-time
adjustments.
•
All user loaded files are deleted.
Result
This reset also removes the
initial serial number passwords and
sets them to no password.
SW HD 4K PLUS Series • Operation
Notes
Use this mode to return
all system settings
to factory defaults
while retaining all IP
settings and the current
firmware version.
This is equivalent
E ZXXX }
to the
SIS command
(see Resetting on
page 16).
Use this mode to
reset all IP and system
settings to factory
defaults while retaining
the current firmware
version.
This is equivalent to the
ZQQQ
SIS command
(see Absolute system
reset
on page 28).
Use this mode to
restart with the default
configuration.
17