Stopping The Device - Tractel Dynafor LLX2 1 t Operation And Maintenance Manual

6.2.4.7 Stopping the device

Display
11
6.2.5 Error Messages
No radio reception
12
GB
6.3 Advanced functions
This chapter presents the functions that enable advanced use of dynafor LLX2
See the general overview of the programme at the end of the manual.
6.3.1 MAIN Menu
13
6.3.1.1 Functions Menu
14
Action
No action
ESC
No action
Select an icon and enable the
available options
Select an icon and enable the
available options
Possible causes
Sensor switched off or switched to the
standby mode (see 27)
Sensor too far from display unit
Network conflict
Confirm selection
Return to standard display
ESC
without modification
Select an icon and enable the
available options
Select an icon and enable the
available options
Confirm selection
Return to standard display
ESC
without modification
Select an icon and enable the
available options
Select an icon and enable the
available options
18
Comments
Arrêt du dispositif :
Keep the ON / OFF button depressed
for 3 seconds to switch off the display
unit.
The sensor automatically moves into
standby mode, and will start up again
when the display unit is switched on.
If necessary you can switch off the
sensor by pressing on the ON / OFF
button.
Solutions
Switch off display unit, switch on
sensor, switch on display unit.
Bring appliances closer together
Check network configuration
(see advanced functions section
6.3.2.4)
Main Menu:
Select MENU.
Confirm with
Select the required sub-menu.
Confirm with
Functions Menu :
Select the required sub-menu.
Confirm with