KEB COMBIVERT G6 Instructions For Use Manual page 22

OPeRATOR PARAMeTeR
os12 operator command
Value Meaning
Default of instructions according to coding (see below)
0 no
1 Load default values in all operator parameters
2 reinitialize PU-parameter-image
os13 operator state
Bit Function
Displays the status of the power unit, as well as the image of the power unit parameter in the control board.
0 Communication to safe-
ty-CPU
1...2 Power unit configurationID
Status
3...5 Power unit-image
Status
6...15 reserved
os15 store mode
Value Meaning
The memory type of non-volatile parameters must be adjusted with this parameter. The parameters will not
be stored if the value is "0", the device automatically changes to value "1" after the next "power-down". This
value is the default value, the non-volatile parameters are always stored. Value „2" deactivates the storing,
also over the next start of the module.
0 curr. off / on at startup
1 on, always store
2 off, never store
os17 safety type
Value Meaning
Type of installed safety module.
0 no safety functionality
1 Type 1
2 Type 2
22
Value Meaning
0 –
1 Communication mistakes to safety-CPU
0 Power unit-ID unknown
2 Power unit-ID OK
4 Power unit-ID incorrect
0 PU-Image not initialized
8 write PU image
16 read PU-Image
24 PU-Image changed
32 PU-Image initialized
40 PU-Image check
48 PU image not available
0 –
0x208C
0x208D
0x208f
0x2091