Completing Assembly - Precor TRM 800 Assembling And Maintaining Manual

Assembling the Treadmill

Completing Assembly

After the upright supports and the fairing are in place, replace
the hood on the treadmill base and finish securing the
fasteners.
CAUTION: Be aware of the handrail extensions when you are
working around the front of the unit. It is easy to bump your head
or sustain other injuries if you ignore the location of the handrail
extensions.
To secure the fasteners:
1.
2. Fully tighten the six screws that secure the console fairing
To complete assembly of the treadmill base:
1.
2. Place the front of the hood on the two front screws. Make
3. Lower the back of the hood until the side screws rest
4. Tighten all four screws securely, starting with the front
Using an alternating order, tighten the eight fasteners that
secure the upright supports to the treadmill base.
to the upright supports.
Important: Use your fingers to align and thread the four hood
fasteners properly. Then use a wrench to tighten the hood
fasteners completely as described in the following step.
Thread the four black buttonhead screws (with black
washers) into their holes, leaving gaps of about ¹₄ inch
between the heads of the screws and the surface of the
treadmill frame.
sure the screws are aligned with the notches in the hood
and the washers are outside the hood.
inside the notches in the internal wall of the hood. Make
sure the washers are outside the internal wall (on the
same side as the screw heads).
screws.
25